- Condition of car for driving test checklist manual#
- Condition of car for driving test checklist plus#
Follow the attachment instructions for your oil pressure kit and mount the tester. Remove the oil pressure sender from the engine block using the proper socket (usually 1 1/16”). Remove the electrical connector from the oil pressure sender. Place an oil drain pan underneath the engine to catch oil spillage. Condition of car for driving test checklist manual#
Check your car’s repair manual if you are unsure where it is.
Locate the engine oil pressure sender near the oil sump on the engine block. For better clearance, lift up the front end of your vehicle, if needed. If everything powers up, the battery is properly installed, and you’re ready to get going. You can try to crank up the engine or turn on the electronics. You can also clean the battery terminals from any build-up issues. Try to remove any corrosion, dirt, or debris from the clamps. Using a skinny wire brush and some water or baking soda, clean the clamps before you add the new battery. Put the battery to the side in a safe spot. The weight of the battery may be over 50 pounds, so get some help if necessary. Loosen the battery hold-down, connectors, and/or fasteners that secure the battery in place. If you are using a tool like a wrench, make sure the metal doesn’t contact the terminal as it will spark. Condition of car for driving test checklist plus#
Remove the positive cable from the positive terminal-the one with the plus sign. Depending on the design of the battery, you may need a wrench to loosen the cable-free. Remove the old battery by removing the negative cable from the negative terminal-the one with the minus sign. 
Pop the car’s hood to access the car’s battery. Remove the clamps in reverse order black clamp from the grounded surface, black clamp from the good battery’s negative post, red clamp from the dead battery, red clamp from the good battery. If the engine doesn’t start, keep the other car running for a few more minutes and try again. Let it run for a few minutes as this will start to recharge the dead battery. On the dead-battery car, connect the other black clamp to an unpainted, grounded-metal part or surface on the dead car, such as the vehicle’s frame. It will have a black cover or a “-” symbol on it. Connect the black clamp to the negative terminal of the live car's battery. Attach the opposite red clamp to the live car battery's positive terminal. It will have a red cover or a “+” symbol on it. 
Connect the red clamp of your jumper cable to the positive terminal of the dead car's battery.Make sure the car with the live battery is NOT running.Replace the car’s fluids oil, coolant, and trans fluid.This article has been viewed 220,023 times. In this case, 100% of readers who voted found the article helpful, earning it our reader-approved status. WikiHow marks an article as reader-approved once it receives enough positive feedback. There are 12 references cited in this article, which can be found at the bottom of the page. RepairSmith offers in-home services to provide car owners convenient and complete auto repair everywhere. RepairSmith was also included in Built in LA’s 50 Startups to Watch and The Business Intelligence Group’s 52 Names Leading the Way in Customer Service. RepairSmith received The 2020 Big Innovation Award by Business Intelligence Group and The Startup of the Year by the American Business Awards. Duston holds an Associate’s degree in Automotive/Diesel Technology from The Universal Technical Institute of Arizona and is a Certified Diagnostic Technician and Automobile Mechanics Technician through BMW STEP. Duston specializes in leading a team that handles a variety of automotive repairs including replacing spark plugs, front and rear brake pads, fuel pumps, car batteries, alternators, timing belts, and starter motors. Duston Maynes is an Automotive Repair Specialist at RepairSmith.
This article was co-authored by Duston Maynes.
0 kommentar(er)
